How to Make an Origami Dragon : Folding Rabbit Ears into Center for Origami Dragon

How to Make an Origami Dragon : Folding Rabbit Ears into Center for Origami Dragon


Now we have our bird base and as you could
see it should look like this. It is just going to be triangles like so. What we are going
to do is we are going to take both of these ends that we have here. We are just going
to pull them until it pops like that. It is going to pop flat so what we are going to
do is then push it down on the table like so. Then it makes a head here. Now we are
going to do something a common fold called rabbit earing. What we are going to do is
push down in the middle here, let’s just get this one out of the way for right now. We
are going to push down in the middle here and bring these 2 ends together. We are just
going to fold and crease here and here and just fold this over here. It is just a simple
rabbit ear. Now we are going to do the same on the other side as well fold it down until
we have our tent. Push down in the middle, bring these 2 together. We want to make sure
both of these rabbit ears are lined in the same direction. These are going to be the
legs for our dragon like so. This is how your model should look at this point here and this
is going to be the head, this is going to be the tail. Here are his legs.

11 thoughts on “How to Make an Origami Dragon : Folding Rabbit Ears into Center for Origami Dragon

  1. I know dosent hebut hes still a good teacher its makien gthis very hard Origami look easy and even kids can do it i think thats talent :3

  2. yes! for you no! because you are only a stupid ignorant! so… ok… you said that it never works, but why are so many origamists on all over the world? it works! and especially this one is very simple and very understandable captured, becausse he used three videos only for a bird base! i think it must fold everyone!

  3. It would help if you would put the next video in the series in the video response field. Otherwise it get confusing since you didn't number the videos.

  4. thats really stupid question u asked i have to make sure the edge is aligned to the crease and edge to edge if u cant c wat ur doin then move the model around to c how to keep folding it

  5. wow, this is rediculous! way to make everyone more confused by not numbering off your videos than being helpful! jeeezzzz

Leave a Reply

Your email address will not be published. Required fields are marked *