Hello there everybody! I am Tadashi Mori and in this video here I will show you how to make this origami Calyx for the Pentagon Rose by Naomiki Sato. To see the tutorial of the rose just click here. And the calyx is based on Naomiki Sato’s diagram and Kade Chan’s video. The original video is right here. And I’d like to say a special thanks for Renelyn Nonato and of course everyone who watches my video. Thanks a lot for your support! Now, let’s start! To make this origami here we will start with one square sheet of paper . The size should be about half of the size of the rose. So, this one here will have 15 cm. Start by folding the origami in half. Now, fold here. Just pinching the bottom part. Now, make a fold like this, going up to the middle line. And just pinch the middle and fold the top part up to the bottom part only pinching the middle again. Now, fold this point up to the middle of this cross. Now, fold the side of this flap up to the side of the model. Now, turn the model over and you’re going to make here a fold along this line. Turn the model over again and fold like this. Now, you’re going to cut the paper along
this line, and the paper should look like this. Now, you’re going to fold the whole model, like this. Alternating valley folds and mountain folds. So, the model will look like this. Now, you’re going to open here this flap. Now, fold one layer to the right, like this. And you’re going to fold this side here, of this flap up to the middle line. Like this, now do the same thing here. and the model will look like this. Now, do the same thing on all the other 4 layers. Now, the model should look like this. Now, let me zoom in here, a little bit. And you’re going to hold here 2 layers, like this and pull making a straight line from one layer to another. Then, you’re going to squash the fold pressing here the sides, carefully. And the model will look like this. Now, you’re going to fold this small flap like this, along along this line here. Now, do the same thing here on all of the other 4 sides. Now, the model will look like this. And you’re going to take here one layer and inside reverse fold. But, at this part, you’re going to align here, with this inner part. So, you have to fold all the way here, to the end. Now, open this flap and fold these sides up to the middle Iine.. So, this side up to the middle line. And do the same thing here ont the other side. And the model will look like this. Now, you’re going to do the same thing to all the other layers. And the model will look like this. Now you’re going to fold this tip. So, hold the model, like this and fold this tip up to this point here, Fold strongly. Also fold to the other direction. Unfold and you’re going to open this layer along this line so, it’s going to be like this. One by one. You’re going to pull the layers and fold along this line. Now, press here, the top. And the model will look like this. So, the model is ready. You just have to take here, the flower and assemble, like this. As you can see, both of them has almost the same size so, we just have to press here. Now, make small curves on the calyx. And the model is done. As you can see, it holds really well. And, that’s it! So, I hope you liked this video. If you liked it, please, don’t forget to click on the ”Like” buttom and to keep up with my new videos, subscribe to my channel. So, that’s it. Thanks for watching my video! See you! Bye bye!