How to Make a Butterfly | Origami

How to Make a Butterfly | Origami


These are the steps for the Origami Butterfly. For the Origami Butterfly we’re going to take
one sheet of paper, start with the colored side up and we’re going to take the bottom
edge going to fold it up to the top edge, this is called a Book Fold. Now go ahead and make sure that their nice
and lined up so there’s no extra color showing. Nice and precise, crease it down. Go to the left, go to the right, and then
open it up and do the same thing on the other side. So this is going to be both of the Book Folds. Then open it up flip it over and now we’re
going to do diagonal folds. This is going to be with the white side up
and we fold these diagonal creases and, again make sure they are nice and precise. Lock it in by sliding your finger down and
then using your thumb to hold it in place and then go off to the side on either side. Open it back up and then we’re going to do
the other diagonal fold so both diagonal folds. Now go ahead and leave that last diagonal
fold there. We’re going to pick up the paper, and right
below these crease lines right here I’m going to put my fingers, my thumb and pointer finger. I’m going to put them both right there, I’m
going to pinch the paper and then rotate the paper up where all four fingers come in to
touch each other. When that happens I am going to squash the
paper down and that’s going to create the base that I’m going to use. This is called a water bomb base in Origami. Make sure that you have two flaps on either
side. So two on one side, two on the other side,
just like that. Next I’m going to fold one flap at the bottom,
the bottom corner. I’m going to fold it up not all the way up
to the point though, just a little bit off, about that far off. Not both flaps, just one flap. On the other side I’m going to take one flap
here too and fold it up about the same distance apart, just like that. Next, flip the whole thing over and I’m going
to take the bottom point of the paper. I’m going to take that bottom point and I’m
going to fold it up. You see how there’s that spot where it doesn’t
want to go any farther? I want to go a little bit past that point. So I’m going to pick it up, and what’s going
to happen when I go up a little bit past that you see how the bottom points start coming
up with the paper. That’s alright, as we work our way over you
can sort of get, this is called a gusset, this little extra piece of paper right there. It’s going to develop like that you stretch
it apart you can flatten that down. So, as we work our way over and sort of stretch
it apart and flatten that little triangular gusset down, just like that. That’s all the wings on both sides of the
butterfly. Go ahead and flip it over. I’m going to fold that whole triangle , that
whole large triangle. Fold the whole thing down , and then go ahead
and bring it up again but not as far as you folded it down. That’s a Pleat Fold, where we fold it down
and then back up, just like that. Next we’re going to fold the whole thing in
half. Take this whole side and bring the whole thing
over to this side. There’s a lot of paper in there so you might
have to push a little harder than your used to but that’s Okay. Next, this is the last step. I’m going to pinch right here, this is the
head of the butterfly. I’m going to pinch right here, I’m going to
fold the wing over and what I want to do, the line I want to make is going to go from
the edge of the head down to this point right here. So, that’s the crease I want to make all the
way over. The same thing on the other side. The two should match up and if you flip it
over and look at it. That right there. That is the finished Origami Butterfly.

13 thoughts on “How to Make a Butterfly | Origami

Leave a Reply

Your email address will not be published. Required fields are marked *