Cutting and lifting bowl form – Clay Craft Malaysia

Cutting and lifting bowl form – Clay Craft Malaysia


If you’re using a wooden tool, hold it in your hand like this, make sure that it’s flat. When you place it down on the wheel head, it should be like this, creating a 45 degree angle. Start your wheel. Place your left hand over your right hand to steady it. Alight your wooden tool parallel to the wall of your bowl, like this. When you’re ready, just move downwards. Then use a needle tool to cut in and remove the excess clay. Tighten your wire tool, press it down to your wheel head and pull it through. Use two fingers, place your fingers like this and peel of your bowl.

Leave a Reply

Your email address will not be published. Required fields are marked *